Yes, we press 6 or 8 to open the gate. I have did not have mgcp dtmf-relay voip codec all mode nse set. In CUCM under the gateway settings, I changed "Type Of DTMF Relay" to NSE. Saved, applied config and then did a no mgcp and then mgcp on the router and tested. Still cannot open the gate. Any other ideas?
Thanks in advance.....Kevin Sent from my iPhone > On Mar 28, 2017, at 10:19 AM, Carlo Calabrese <[email protected]> > wrote: > > I take it you press 6 or something to allow the gate to open? can you send a > copy of the MGCP statements on the gateway? > > looking to see what the dtmf-relay is set to. > > mgcp dtmf-relay voip codec all mode nse > > > On Tuesday, March 28, 2017 6:46 AM, Brian Meade <[email protected]> wrote: > > > We'd need some debugs to see what is happening like "debug vpm signal" to see > what tones are sent on the line. > > On Tue, Mar 28, 2017 at 9:35 AM, Kevin via cisco-voip > <[email protected]> wrote: > > Hi, > > I was wondering if a solution was found. > > I have a similar issue. We have a Viking gate opener that was connected to a > Nortel Option 11c analog port. We have migrated to a CUCM. The local analog > port is now an FXS port on a Cisco 4331 router using MGCP. The call box at > the gate works in that I can call from the call box to a Cisco IP phone and a > two way connection works. But when the code is entered on the IP phone to > open the gate, the call drops and the gate does not open. > > Thanks in advance. > Kevin > Sent from my iPhone > ______________________________ _________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/ mailman/listinfo/cisco-voip > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
