You might want to download again the image from the Cisco site and give it
another shot.
I don't think it's version-related.
Henry
-----Original Message-----
From: Jamie Byrne [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, May 16, 2000 9:32 AM
To: Circusnuts; [EMAIL PROTECTED]
Subject: Re: Checksum Errors after loading IOS
I've only seen this happen occasionally, and each time I chalked it up to
file corruption during the transfer. On all occasions, deleting and
squeezing the image, then copying it to flash again did not see the same
checksum error.
Jamie Byrne
At 11:47 PM 5/15/00 -0100, Circusnuts wrote:
>>>>
I have successfully upgraded 3X Cisco 3000's to run Enterprise IOS's. I'm
not real up on the error I'm getting "after" the IOS is copied into FLASH...
Verifying checksum... invalid (expected 0xB482, computed 0x8024)
Any ideas... 11.3 & 12.0 both showed this error, but 11.2 did not.
Here is the show version...
BOOTFLASH: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c)XB1,
PLATFORM
SPECIFIC RELEASE SOFTWARE (fc1)
System image file is "flash:11Enterprise.MZ", booted via flash
cisco 3000 (68030) processor (revision 0xA0) with 16384K/512K bytes of
memory.
Processor board ID 5007660, with hardware revision 00000000
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
Thanks !!!
Phil
<<<<
___________________________________ UPDATED Posting Guidelines:
http://www.groupstudy.com/list/guide.html FAQ, list archives, and
subscription info: http://www.groupstudy.com Report misconduct and
Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
