I didn't see anything wrong with your config, I would suggest you
checking the routing table on host 10.0.0.115 . Make sure it knows how
to get back your network 10.0.10.0 via 10.0.0.250. It's very likely that
your ping is getting to the host, but the reply is not getting back to
your router.
Tim
Becky wrote:
> I feel pretty stupid - I've just passed the CCNA this past Friday
> and am trying to get a simple 4000M 10baseT router to pass
> traffic from one segment to another. I just got this router to play
> with - yes, I passed the CCNA with out any real hands-on...(I know,
> I know - let the paper-cert debates begin...*grin*)....anyway, here
> is a copy of an extended ping:
>
> Internal1#ping
> Protocol [ip]:
> Target IP address: 10.0.0.115
> Repeat count [5]:
> Datagram size [100]:
> Timeout in seconds [2]:
> Extended commands [n]: y
> Source address or interface: 10.0.10.1
> Type of service [0]:
> Set DF bit in IP header? [no]:
> Validate reply data? [no]:
> Data pattern [0xABCD]:
> Loose, Strict, Record, Timestamp, Verbose[none]:
> Sweep range of sizes [n]:
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 10.0.0.115, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5)
>
> I don't understand why I can't ping an address on my 10.0.0.0 segment
> from the 10.0.10.1 interface of my router???? I'm embarrassed to
> be asking this because I fear the answer is so simple, but then again
> I was taught to never be afraid to ask even stupid questions.... ;-)
>
> So, here's my config and I would appreciate any words of wisdom.
>
> Regards,
> Becky
>
> Current configuration:
> !
> version 12.0
> service timestamps debug uptime
> service timestamps log uptime
> no service password-encryption
> !
> hostname Internal1
> !
> enable secret 5 $1$
> enable password
> !
> ip subnet-zero
> !
> !
> !
> interface Ethernet0
> ip address 10.0.0.250 255.255.255.0
> ip directed-broadcast
> media-type 10BaseT
> !
> interface Ethernet1
> ip address 10.0.10.1 255.255.255.0
> ip directed-broadcast
> media-type 10BaseT
> !
> ip classless
> ip route 0.0.0.0 0.0.0.0 10.0.0.1
> !
> dialer-list 1 protocol ip permit
> dialer-list 1 protocol ipx permit
> !
> line con 0
> transport input none
> line aux 0
> line vty 0 4
> password
> login
> !
> end
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
