Routing protocol in use on router A is OSPF.
Routers B and C are not under my control, and while they too use OSPF, I would
prefer to use static routes to the destination networks, as they have LARGE
amounts of routing entries.

The two serial links from B and C are both FR T1's.




|--------+----------------------->
|        |          walawson@cisc|
|        |          o.com        |
|        |                       |
|        |          07/14/00     |
|        |          09:39 AM     |
|        |                       |
|--------+----------------------->
  >--------------------------------------------------------|
  |                                                        |
  |       To:     [EMAIL PROTECTED],                   |
  |       [EMAIL PROTECTED]                             |
  |       cc:                                              |
  |       Subject:     RE: Load Balancing between two      |
  |       routers                                          |
  >--------------------------------------------------------|





 Sure, you definitely can,  part of the config would depend on what routing
protocol you're running - are the
routes the same cost?  (What is the speed of the circuits between B and the
final destination, and C and the
final destination.   Post that info and I'm sure we can hook you up with a
configuration.

Wayne Lawson, SE - Cisco Systems
CCIE # 5244, CCNA & CCDA, Nortel NCSE,
MCSE, CNE, CBE, CNX Ethernet

2000 Town Center, Suite 450
Southfield, MI. 48075
248.455.1663 (Direct Voice)
248.709.5797 (Cellular)
248.455.1699 (Fax)
800.365.4578 (Msg. Center)
<http://www.cisco.com>



"EMPOWERING THE
INTERNET GENERATION"

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
[EMAIL PROTECTED]
Sent: Friday, July 14, 2000 8:56 AM
To: [EMAIL PROTECTED]
Subject: Load Balancing between two routers

I have three routers connected via token ring, A, B, & C.
Routers B & C both have serial links to the same location.
Can I configure router A to balance the traffic between routers R & C.
Currently using static routes in A to send traffic to B only.
Thanks!
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]





___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to