Ok, try this......
1. Even though you removed the NAT statements from the interfaces, there
are still translations in the router. Do a "show ip nat translation" to
see if there are any. If there are, the issue the command "clear ip nat
translation" to remove them. After you remove them, you should have no
trouble doing what you need to do.
2. If number 1 didn't work on it's own, the make sure that all NAT
statements have been removed from the interfaces, reload, then take care
of business.
I hope that this helps!
Michael W. Oliver
[EMAIL PROTECTED]
-----Original Message-----
From: Niraj Palikhey [mailto:[EMAIL PROTECTED]]
Sent: Monday, July 31, 2000 4:45 PM
To: [EMAIL PROTECTED]
Subject: Removing NAT??
Hi,
I have enable dynamic nat on a 2501 and cannot take it out. It gives me an
error msg. "Pool Internet in use;Cannot redefine". "Dynamic mapping in
use.
Cannot remove"
Basically, instead of specifying a legal range of addresses for the pool,
I
specified the internet addresses 10.11.10.2 through 10.11.10.20.
I also have access list 1 specified for 10.11.10.0 0.0.0.255.
I have for E0 - ip nat inside and for S0 - ip nat outside
What do I do first to modify the ip nat pool Internet line to include the
legal range?
I first removed the access-list and then the nat for both s0 and e0? I
still
get the error msg. I did a no ip nat .... and still get the error msg.?
Please advise
Thank you.
Kind regards,
[EMAIL PROTECTED]
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
smime.p7s
