I have a 1600 series router that is not booting. I gives me the Router(boot)> prompt when it boots. Can someone tell me how to get it to boot properly. Here is the output: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C1600 platform with 8192 Kbytes of main memory program load complete, entry point: 0x4020060, size: 0x165eac %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem? %SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader. %Error opening tftp://255.255.255.255/cisco2-C1600 (Timed out)boot of "cisco2-C1 600" using boot helper "eprom:c1600-rboot-r.120-3.T" failed error returned: File read failed -- Timed out loadprog: error - on file open boot: cannot load "cisco2-C1600"j System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C1600 platform with 8192 Kbytes of main memory device does not contain a valid magic number boot: cannot open "flash:" boot: cannot determine first file name on device "flash:"j System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1) Copyright (c) 1999 by cisco Systems, Inc. C1600 platform with 8192 Kbytes of main memory program load complete, entry point: 0x4020060, size: 0x165eac Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) 1600 Software (C1600-RBOOT-R), Version 12.0(3)T, RELEASE SOFTWARE (fc1 ) Copyright (c) 1986-1999 by cisco Systems, Inc. Compiled Mon 22-Feb-99 23:05 by ccai Image text-base: 0x04020060, data-base: 0x02005000 cisco 1601 (68360) processor (revision C) with 7680K/512K bytes of memory. Processor board ID 16986793, with hardware revision 00000002 1 Ethernet/IEEE 802.3 interface(s) Unrecognized interface found (0-1 = Motherboard interfaces 2 = WIC) Interface 1 unrecognized by boothelper Interface 2 unrecognized by boothelper System/IO memory with parity disabled 8192K bytes of DRAM onboard System running from ROM 8K bytes of non-volatile configuration memory. 4096K bytes of processor board PCMCIA flash (Read/Write) %Error opening tftp://255.255.255.255/network-confg (Timed out) %Error opening tftp://255.255.255.255/cisconet.cfg (Timed out) %Error opening tftp://255.255.255.255/router-confg (Timed out) %Error opening tftp://255.255.255.255/ciscortr.cfg (Timed out) Press RETURN to get started! 00:00:01: %C1600-4-INTFCNOFLH: Unable to load images or communicate over interf ace 00:00:01: %C1600-4-INTFCNOFLH: Unable to load images or communicate over interf ace 00:00:03: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up 00:00:04: %SYS-5-CONFIG_I: Configured from memory by console 00:00:04: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem? 00:01:04: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software IOS (tm) 1600 Software (C1600-RBOOT- Router(boot)> Router(boot)> Router(boot)> Router(boot)> Router(boot)>R), Version 12.0(3)T, RELEASE SOFTWARE (fc1) Copyright (c) 1986-1999 by cisco Systems, Inc. Compiled Mon 22-Feb-99 23:05 by ccai 00:01:04: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem? Router(boot)> Here is the output of the "show version": Cisco Internetwork Operating System Software IOS (tm) 1600 Software (C1600-RBOOT-R), Version 12.0(3)T, RELEASE SOFTWARE (fc1 ) Copyright (c) 1986-1999 by cisco Systems, Inc. Compiled Mon 22-Feb-99 23:05 by ccai Image text-base: 0x04020060, data-base: 0x02005000 ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1) fdle1600 uptime is 1 minute System restarted by power-on System image file is "bootflash:" cisco 1601 (68360) processor (revision C) with 7680K/512K bytes of memory. Processor board ID 16986793, with hardware revision 00000002 1 Ethernet/IEEE 802.3 interface(s) Unrecognized interface found (0-1 = Motherboard interfaces 2 = WIC) Interface 1 unrecognized by boothelper Interface 2 unrecognized by boothelper System/IO memory with parity disabled 8192K bytes of DRAM onboard System running from ROM 8K bytes of non-volatile configuration memory. 4096K bytes of processor board PCMCIA flash (Read/Write) Configuration register is 0x2102 Thanks.
--------------------------------- Do you Yahoo!? Yahoo! Tax Center - File online, calculators, forms, and more Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=66850&t=66850 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
