What does the physical layer say? sh controller (intf) Martijn
-----Oorspronkelijk bericht----- Van: Jablonski, Michael [mailto:[EMAIL PROTECTED] Verzonden: dinsdag 29 juli 2003 0:24 Aan: [EMAIL PROTECTED] Onderwerp: NM-1HSSI w/kentrox DataSMART T3/E3 [7:73129] Has anyone had any experience w/the following combination? 3640 & NM-1HSSI & Kentrox DataSMART T3/E3 IDSU I've been trying, to no avail, to bring the HSSI up for a 12M DS3.... The CSU/DSU, according to the lights, is ready to send and receive data; but when I bring up the int on the router, it shows down down. Here's the router info: ~~~~~~~~~~~~~~~~~~~~~~~~~~~ interface Hssi1/0 bandwidth 12000 ip address x.x.x.x 255.255.255.252 serial restart_delay 0 no cdp enable Hssi1/0 is down, line protocol is down Hardware is M1T-HSSI-B Internet address is x.x.x.x/30 MTU 4470 bytes, BW 12000 Kbit, DLY 200 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation HDLC, crc 16, loopback not set Keepalive set (10 sec) Restart-Delay is 0 secs Last input never, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue :0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 parity 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 applique, 8 interface resets 0 output buffer failures, 0 output buffers swapped out 13 carrier transitions LC=down CA=down TM=down LB=down TA=up LA=down Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=73144&t=73129 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
