and while I'm asking........
getting lots of use out of the lab here..........
I've got 3 4700/4500s with an ATM interface, a 7505 with ATM and an LS-1010.
Using a config from Hutnick, I can't seem to get connectivity.
On page 287 for the cmd "sh atm vc", Status is shown as "ACTIVE".
I only see "UP". Also, I can't ping from one ATM router to the other.
On the LS-1010, I see "UpAndNormal" for the ILMI state and "Idle" for the
SSCOP state.
Sitting on any router, (telnet in) I cannot ping the ATM interface of that
router, but I can ping any other address on the router as well as stuff on
the lab network.
Any thoughts? No special config here, bare bones just trying to get from
router to router over ATM.
tia
Kevin Wigle
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
