Kevin,
Not sure with out seeing your config but try mapping the destination
address of the PVC:
int ATM2/1
ip address 220.1.1.1 255.255.255.0
atm pvc 10 0 32 aal5snap
map-group trythis
!
map-list trythis
ip 220.1.1.2 atm-vc 10
-Scott
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
> Kevin Wigle
> Sent: Tuesday, September 26, 2000 11:01 AM
> To: cisco
> Subject: ATM Config
>
>
> and while I'm asking........
>
> getting lots of use out of the lab here..........
>
> I've got 3 4700/4500s with an ATM interface, a 7505 with ATM and
> an LS-1010.
>
> Using a config from Hutnick, I can't seem to get connectivity.
>
> On page 287 for the cmd "sh atm vc", Status is shown as "ACTIVE".
>
> I only see "UP". Also, I can't ping from one ATM router to the other.
>
> On the LS-1010, I see "UpAndNormal" for the ILMI state and "Idle" for the
> SSCOP state.
>
> Sitting on any router, (telnet in) I cannot ping the ATM
> interface of that
> router, but I can ping any other address on the router as well as stuff on
> the lab network.
>
> Any thoughts? No special config here, bare bones just trying to get from
> router to router over ATM.
>
> tia
>
> Kevin Wigle
>
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
