On Wed, 8 Nov 2000, Hans Schimek wrote:
> Hi!
>
> i configured a serial link and an ISDN link between two routers.
> the serial line is the primary line. if it fails the backup line
> ISDN-Interface)
> takes over.
> i configured RIP -
> To prevent Routing Updates from establishing the call
> i set the ISDN-Interface as PASSIVE.
> Updates didn`t initate the call anymore.
> BUT !
> what about the routing information. if the primary fails, no routing updates
> won`t flow. so i configured static routes with a higher administrative
> distance
> -
configure the static route with a high AD like you did. Don't make the
BRI passive, instead just use a dialer-list to define RIP as
"uninteresting". Something like this:
interface BRI0
ip address 192.168.1.1 255.255.255.240
encapsulation ppp
bandwidth 128
isdn spid2 00055512130101
dialer map ip 192.168.1.2 5551212
dialer-group 1
!
router rip
network 192.168.1.0
!
ip route 0.0.0.0 0.0.0.0 192.168.1.2 240
access-list 101 deny udp any any eq rip
access-list 101 permit ip any any
!
dialer-list 1 protocol ip list 101
>
> IS THERE ANOTHER SOLUTION FOR THAT PROBLEM !
>
>
> thanx in advance
>
>
>
>
> =============================
> Hans Schimek
>
> Student
> Fachhochschule St. P�lten f.
> Telekommunikation und Medien
>
> mailto: [EMAIL PROTECTED]
> gsm : +43 699 10605315
> fax : +43 3613 2311 4
> icq : 22308773
> www : www.schimek.net
>
> =============================
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
-----------------------------------------------
Brian Feeny, CCNP, CCDP [EMAIL PROTECTED]
Network Administrator
ShreveNet Inc. (ASN 11881)
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
