Chan,
It's been quite a while since I've taken BCMSN, but I don't believe there
were any fill-in-the-blank CLI questions, though I believe there were a few
multiple-choice ones. VLANs and VTP operations, spanning-tree and MLS were
covered pretty thoroughly on the exam. I recall few to zero questions about
HSRP, and very little on multicasting, though you should be familiar with
the basic operations and commands associated with each. There is the usual
product selection associated with all the CCNP exams. In addition, there
are quite a few management and troubleshooting questions about LEDs,
configuring the switch, etc. Overall not too difficult an exam if you read
through it carefully. Good luck.
~Seth~
----- Original Message -----
From: "Chiao Liang" <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Wednesday, January 17, 2001 6:40 AM
Subject: CCNP-BCMSN
> Hi all
>
> Like to find out from u guy about the exam, will there be lot of CLI
> config command being tested. Any advise for the paper as well.
>
> Thank
> Chan
> CCNA , CCDA
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
