Actually, you don't want it to be read/write. In 0x2102 mode, it should read
read only. You will be able to TFTP a new image in this mode.
Kelly D Griffin, CCNA, CCDA
Network Engineer
Kg2 Network Design
http://www.kg2.com
----- Original Message -----
From: "Hans Stout" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, February 02, 2001 4:26 PM
Subject: System Flash Read Only
> Hi colleagues,
>
> I just installed some third party flash memory into my 2501, and the 'sh
> ver' says that the system flash is read only. How can I change that to
> read/write ? Is that a configuration register setting ? Or a jumper
setting
> ?
> Thanks for your advice in advance.
>
> Regards,
>
> Hans
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ____________________________________________
> http://1cis.com
> Free E-mail Servers with unlimited mailboxes
> 1st Class Internet Solutions
____________________________________________
http://1cis.com
Free E-mail Servers with unlimited mailboxes
1st Class Internet Solutions
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
