Hi Hans,
The flash in the 2500 always said read-only. This platform runs the IOS from
flash, therefore when the router is running the flash is read-only as not to
write over the IOS. There is a boot helper mode (config register 0x2101) which
you can go to, to change the IOS image.
Rich
On Feb 2, 11:37pm, Hans Stout chatted about:
> Subject:System Flash Read Only
> Hi colleagues,
>
> I just installed some third party flash memory into my 2501, and the 'sh
> ver' says that the system flash is read only. How can I change that to
> read/write ? Is that a configuration register setting ? Or a jumper setting
> ?
> Thanks for your advice in advance.
>
> Regards,
>
> Hans
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>-- End of waffle from Hans Stout
--
*** Please copy your emails to [EMAIL PROTECTED] ***
#-----------------------------------------------------------------------#
# .. .. | Richard Gallagher | Office:+32 2 704 5000 #
# || || | Euro-CATS | Direct:+32 2 704 5421 #
# || || | Cisco Systems Belgium | Fax: +32 2 704 6000 #
# |||| |||| | Pegasus Park | email: [EMAIL PROTECTED] #
#.:||||||:.:||||||:.| De Kleetlaan, 6A | #
# Cisco Systems | BE 1831 Diegem | http://www.cisco.com/tac #
#-----------------------------------------------------------------------#
"Normal people believe that if it ain't broke, don't fix it. Engineers
believe that if it ain't broke, it doesn't have enough features yet."
Check out this link: http://www.cisco.com/warp/customer/63/
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
