Hi All :
Here is a
scenario I have encountered. This GSR 12008 actually
is served as a Internet Exchange router between A
B & C location. The basic requirment for this
router is to run BGP4. However, this router have a 1 port
Gigabit Ethernet line card connected to a 6509 8 port
Gigabit Ethernet module, C also have a gigabit
Ethernet port connected to this 8 port module. Everthing
is fine and until recently, when the traffic of over the
gigabit Ethernet go over 200MBit/s for a period, the interface
will automaticaly die. (Die here means no traffic flow in
and out for the Gigabit Ethernet line card of the GSR).
I would like to resolve
this problem. I think IOS 12.0(9)S is not some how stable but which IOS
should be used?
1 Route Processor Card
2 Clock Scheduler Cards
3 Switch Fabric Cards
2 four-port OC3 POS controllers (8 POS).
1 Single Port Gigabit Ethernet/IEEE 802.3z controller (1
GigabitEthernet).
1 Ethernet/IEEE 802.3 interface(s)
1 GigabitEthernet/IEEE 802.3 interface(s)
8 Packet over SONET network interface(s)
507K bytes of non-volatile configuration memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x102
Thanks !
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
