Hi Guys
Windows 2000 employs power management, and this can cause problems, disable.
Windows NT you cannot issue the break sequence, solution is to drop the baud
rate to 2400 or so, save the configuration, reload router, while booting
(within 30seconds) change baud rate back to 9600 holding down space.
Other than that as Cyndi mentioned use another term application.
/Stuart
-------------------------------------------------------------------------
| | Stuart Potts
||| ||| Customer Support Engineer
.|||||. .|||||.
.:|||||||||:.:|||||||||:.
c i s c o S y s t e m s Email: [EMAIL PROTECTED]
"Empowering the Internet Generation"
-------------------------------------------------------------------------
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Garrison, Cyndi D.
Sent: Tuesday, March 06, 2001 2:17 PM
To: 'Navin Parwal'; [EMAIL PROTECTED]
Subject: RE: Cisco Configuration Help
I have found that one of the more currnet versions of hyperterminal will not
work with the console of some of the cisco routers. I have not figured out
whether it is the IOS or just the hyperterminal. Try upgrading your
hyperterminal program or using another program. If that is not possible try
a another desktop or laptop with Windows NT or 98. I have windows 2000 and
have run into the same problem.
Cyndi Garrison
-----Original Message-----
From: Navin Parwal [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, March 06, 2001 7:23 AM
To: [EMAIL PROTECTED]
Subject: Cisco Configuration Help
Hello Everyone ,
I am new on Cisco routers and Switches , I am facing a problem on
a new Cisco router 2610 which my company has purchased .
I am able to telnet on to that router via other router , but I am not
able to configure with the console port , as soon as i start it with the
console port , it starts , displays the welcome message and then it shows
the status of the iinterfaces which has come up , but it does not come to
the user mode , ie cisco> prompt .
When I telnet it from the other router I am able to log in giving the
telnet password and I am able to configure it then but I am not able to get
the prompt from my console which is on Windows Millemium , could anyone
guide me why this error is coming and how I may correct it .
thanks in advance,
Navin Parwal
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
