Hello Everyone ,
I am facing a problem while configuring RIP on my network , my network
is as follows, I have given some more details over here as compared to my
previous posting :
I have two Cisco 2600 series routers which are connected back to back .
1) On the fisrst Router Cisco2610 my configuration is as follows :
Ethernet0/0 11.100.10.1
Serial0/0 200.100.10.1
2) On the second Router Cisco2620 my configuration is as follows :
Ethernet0/0 192.168.1.1
Serial0/0 200.100.10.2
My subnet masks set are all default , it for 11.100.10.1 it is 255.0.0.0 ,
for 200.100.10.1 it is 255.255.255.0 .
Similarly for the second router it is 192.168.1.1 given is 255.255.255.0
and for the 200.100.10.2 it is 255.255.255.0 .
I am able to ping from one end of the ethernet of one router to another
when I configure the routing table statically , but when I am giving the
following commands for dynamic routing on both of the router :
1) on 2610 config) router rip
network 200.100.10.0
2) on 2620 config) router rip
network 200.100.10.0
It mentions that gateway of the last resort is not set on both of these
commands
On my second router ie 2620 , when I give the command sh ip route , I get
the following entry in my routing table for the serial interface :
200.100.10.0/24 is variably subnetted , 2 subnets , 2 masks
c 200.100.10.0/24 is directly connected , serial0/0
c 200.100.10.1/32 is directly connected , serial0/0
I am not able to view the RIP (R) entries when I give the command show ip
route on both of the routers , it shows me only all the directory connected
interfaces and gives me a message that gateway not set.
When I give the command show ip Protocols , it shows me that RIP is
running .
What could be the error I am making , please let me know .
I am new on routers and switches .
thanks,
Navin Parwal
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
