hey listers!
anyone know a quick and dirty way to parse some info from the sho interface
command, like interface utilization, etc ? I tried that cisco tool, but it
only tells you what is possibly wrong not the interface utilization.
thanks,
jason
this is from a 2924 catalyst switch.
FastEthernet0/9 is up, line protocol is up
Hardware is Fast Ethernet, address is 00d0.baaa.bc0a (bia 00d0.baaa.bc0a)
Description: BIG IP
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set
Half-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters 03:12:31
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 298000 bits/sec, 87 packets/sec
5 minute output rate 218000 bits/sec, 79 packets/sec
2789509 packets input, 1003512202 bytes, 0 no buffer
Received 1319 broadcasts, 0 runts, 0 giants, 0 throttles
4 input errors, 4 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
2693936 packets output, 753564104 bytes, 0 underruns
0 output errors, 33701 collisions, 0 interface resets
0 babbles, 0 late collision, 25705 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
