I am using a Cisco 2505 router which has a built in 8 port hub. This hub
acts as 1 ethernet interface and I would like to use NAT to allow a network
that is connected to the built in hub to be able to connect out to the
internet through another port on the hub using 1 globally routable address
with overloading. I tried using both "ip nat inside" and "ip nat outside" on
the ethernet interface, but you can only use one of those commands on an
interface. I played with different configurations yesterday and couldn't get
any to work correctly. Should I be able to accomplish this? If anyone could
help that would be greatly appreciated. Thanks
Justin Emilio
Tech Support
CCNP, CCNA, CCDA, CSE
MM Internet 888-654-4971
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=3073&t=3073
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
