No you can't. The hub is just that - a hub. There is only one interface. If
you connected to the Internet via your serial port then the following config
should work. If you need ethernet on the Internet side, then time to buy a
router with two ethernet interfaces.
ip nat inside source list 1 interface Serial0 overload
interface serial 0
ip address aaa.xxx.yyy.zzz 255.255.255.0
ip nat outside
interface Ethernet0
ip address 9.114.11.39 255.255.255.0
ip nat inside
access-list 1 permit 9.114.11.0 0.0.0.255
> -----Original Message-----
> From: Justin Emilio [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, May 03, 2001 12:46 PM
> To: [EMAIL PROTECTED]
> Subject: IP NAT Issue [7:3073]
>
>
> I am using a Cisco 2505 router which has a built in 8 port
> hub. This hub
> acts as 1 ethernet interface and I would like to use NAT to
> allow a network
> that is connected to the built in hub to be able to connect out to the
> internet through another port on the hub using 1 globally
> routable address
> with overloading. I tried using both "ip nat inside" and "ip
> nat outside" on
> the ethernet interface, but you can only use one of those
> commands on an
> interface. I played with different configurations yesterday
> and couldn't get
> any to work correctly. Should I be able to accomplish this?
> If anyone could
> help that would be greatly appreciated. Thanks
>
>
> Justin Emilio
> Tech Support
> CCNP, CCNA, CCDA, CSE
> MM Internet 888-654-4971
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct
> and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=3081&t=3073
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
