You can't do full on a hub. Put your routers back to half and it will
probably work. If not, make sure your workstations didn't auto-screwup
and go full as well.
Mike
Sammi wrote:
> I have the router interfaces on full/100, perhaps I'll move it to
> auto, same as the workstations are.
> I have moved equipment, swapped cables, haven't seen anything
> suspicous. I lose link lights on the hub and on the router, just
> doesn't come back soon's I go to the second hub.
> I'm not at the office, but I don't believe the hub has cachine
> capability.
>
> I will try putting the interfaces into auto tomorrow, thanks all!
>
> On 16 Aug 2001 22:18:56 -0400, [EMAIL PROTECTED] ("Mark & Monica
> Baker") wrote:
>
>
>>Have you tried moving things around to see if the problem follows any
piece
>>of equipment? Maybe a bad cable, bad port on hub, or speed/duplex
mismatch.
>>Have you tried rebooting router after adding hub? Do you lose link lights
>>on the hub (and if so, is it just where the router plugs in, or on the
>>workstations?) or the router or both? Could the original hub be caching
the
>>MAC of the router port that was plugged into it and think it's still on
the
>>original port, instead of moved to another hub?
>>
>>Mark
>>
>>-----Original Message-----
>>From: Sammi [SMTP:[EMAIL PROTECTED]]
>>Sent: Thursday, August 16, 2001 9:27 PM
>>To: [EMAIL PROTECTED]
>>Subject: Hub to Hub through 2600 [7:16328]
>>
>>Hello,
>>I just received a 2616 router. I set it up through the initial boot
>>screen:
>>
>>SubA - 0/0 10.100.1.1 /16
>>SubB - 0/1 10.200.1.1 /16
>>
>>Everything works fine if both interfaces are connected, via straight
>>cable, to a 3Com 10/100 hub. Can ping either interface from either
>>subnet, all machines on each subnet can ping any machine on other
>>subnet.
>>
>>However, when I try to go with two hubs, one for each subnet, I can no
>>longer communicate. Have assured I'm not on uplink, have tried uplink,
>>am sure no problems with hub (new out of box, and working in other
>>configs).
>>
>>If I have both Subs hooked up to one hub, all link lights are green.
>>If I move one of the interfaces to the other hub, no link light.
>>
>>Am I missing something? I'm sure it's something simple but heck if I
>>know.
>>
>>Any help greatly appreciated.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=16538&t=16328
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
