RIP is a classful protocol, and so assigns each network statement a mask
based on the first octet of the statement. So 192.168.x.x is automatically
a class C network since its first octet starts in the Class C range. Try
putting each class C in the configuration with the network statement,
192.168.254.0, 192.168.100.0, and 192.168.50.0. The statement "network
192.168.0.0" says that only interfaces within the 192.168.0.1-254 range are
participating in RIP. Hope this solves the problem.
Guy
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, September 05, 2001 4:39 AM
To: [EMAIL PROTECTED]
Subject: CCNA question with routing setup [7:18572]
I have 2 2501 routers setup as follows:
RouterA eth0 with 192.168.254.1/24
RouterA serial 0 with 192.168.100/24
setup as DTE, no shutdown, router rip
network 192.168.0.0
RouterB eth0 with 192.168.50.1/24
RouterB serial 0 with 192.168.100.11/24
setup as DCE, clock rate 64000, no shutdown, router rip
network 192.168.0.0
My problem is it won't see any of the networks...do I have this number setup
wrong? when I setup a static IP ROUTE..the networks work fine and see each
other its just with RIP for some reason is unable to see the other
networks...what am I doing wrong?
thank you all
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=18575&t=18572
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
