If memory serves, this has been discussed on the CCIE list, complete with
solutions. Try searching the archives at:
http://www.groupstudy.com/cgi-bin/wilma/ccielab
best wishes
Chuck
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Rick Harville
Sent: Tuesday, September 11, 2001 8:15 AM
To: [EMAIL PROTECTED]
Subject: Back to back ISDN [7:19414]
I have received several responses sofar expressing a great interest in the
solution. Back to back ISDN over a single ISDN line seems to be a very
acceptable approach to simulating DDR. Unfortunately, nobody seems to be
able to confirm that it can be done. A seach of archives reveals discussions
but no real verification that this is possible. The p If anyone has actually
done this please respond as there seems to be a great interest in doing
this.
Once again, the question is, can you connect two BRI (st) interfaces through
a NT1 device using only a single ISDN line?
I have 2 Cisco 2503's with st Bri. Im using Motorola NT1 device with a
single U interface and 2 ST ports. I have at my disposal a single ISDN line
from SW Bell. I would like to split the spids at the nt1 device and practice
my DDR with only one spid on each router.
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=19425&t=19414
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
