> Sure but I'm at a loss to understand what good it would do.
If the 2511 was the hub of a hub and spoke WAN, and there was an application
between the other two sites that required bridging, that's what good it
would do.
>
> Dave
>
> "Lupi, Guy" wrote:
>
> > Can you configure bridging using only serial interfaces, no ethernet
> > involved at all? I have a 2501 connected to a 2511, and a 2503
connected
> to
> > the same 2511, both via serial. I want to configure the 2 serial
> interfaces
> > on the 2511 to bridge between them, is that possible? There is no
> practical
> > reason for this, just setting it up in the lab and I am curious.
Thanks.
> --
> David Madland
> CCIE# 2016
> Senior Network Engineer
> Qwest Communications
> 612-664-3367
_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20103&t=20078
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
