THANKS!
-----Original Message-----
From: Duncan Personal
Sent: Mon 11/26/2001 2:55 AM
To: Pierre-Alex J. Guanel
Cc:
Subject: RE: Slimline 2 [7:27365]
Hi Pierre-Alex,
The PDS SDN simulator conforms to the European
Telecommunications Standards
Institute. I believe you need to configure basic-net3 as your
switch-type.
Regards
Duncan
-----Original Message-----
From: [EMAIL PROTECTED] [ mailto:[EMAIL PROTECTED]]On
Behalf Of
Pierre-Alex J. Guanel
Sent: 26 November 2001 21:02
To: [EMAIL PROTECTED]
Subject: Slimline 2 [7:27365]
I am using the Slimline 2 ISDN simulator from PDS technologies.
I cannot get the SPID to be accepted. (See below)
ISDN BRI0 interface
dsl 0, interface ISDN Switchtype = basic-5ess
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 64, Ces = 1, SAPI = 0, State =
MULTIPLE_FRAME_ESTABLISHE
TEI 64, ces = 1, state = 4(await init)
spid1 configured, no LDN, spid1 sent, spid1 NOT
valid
I have not modifed the default phone numbers 1111 and 2222
configured on
Slimline
Below are my configs for bri0
interface BRI0
ip address 10.0.0.1 255.255.255.0
encapsulation ppp
no ip route-cache
no ip mroute-cache
dialer map ip 10.0.0.2 1111
dialer-group 1
isdn switch-type basic-5ess
isdn spid1 2222
Is there a default LDN number I have to configure?
Pierre-Alex
[EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=27374&t=27365
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
