I think a lot of the issue is, that in the past it did not work because the 10mb chipset in the older routers did not support the sub-intf and vlan trunking.
The newer chipsets may well have the ability to do that and Dave has come across something that is included in the IOS and that is supported in the hardware. Larry Letterman Cisco Systems [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of MADMAN Sent: Thursday, March 28, 2002 12:34 PM To: [EMAIL PROTECTED] Subject: Re: If it's a 2611, you're out of luck [7:39788] I didn't make it work yet but I sent this: C2612A(config)#int e0/0.1 C2612A(config-subif)#enca C2612A(config-subif)#encapsulation ? dot1Q IEEE 802.1Q Virtual LAN sde IEEE 802.10 Virtual LAN - Secure Data Exchange Dave Larry Letterman wrote: > > apparently last week some one on the list made the ethernets work > in a 2600 router at 10mb.... > > Larry Letterman > Cisco Systems > [EMAIL PROTECTED] > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] > Sent: Thursday, March 28, 2002 10:15 AM > To: [EMAIL PROTECTED] > Subject: If it's a 2611, you're out of luck [7:39788] > > Vlan trunking requires a fast ethernet connection. It cannot be trunked > with a 261X. You'd need a 262X. > > If you have to deal with a 2611, your options become much more limited. You > could replace the 2611 with a 2620. Or you could get a ethernet module for > the 2611. Unfortunately, last time I checked (whish was a couple years ago, > given) those ethernet modules came in two models, 1 and 4 port, and cost > about $1000 per port. > > Another option would be to replace the 2611 with a 1750. It's got one fast > ethernet port. If this network is as small as it sounds, it'd be a viable > option. > > Oh, and about trunking, the way it works is you define the switch port > connected to the router as a trunk. This allows multiple (in your case, > all) vlans to use the one port. The router is configured with subinterfaces > on the fastethernet port, one for each vlan. The router can then route > between these vlans. -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=39852&t=39788 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
