Kind of a silly problem but can't figure it out ...
I am connected to R1 via telnet. I have turned on debugging of ip packets
I also have issued the command "terminal monitor"
Yet I do not get anything logged when I ping the Ethernet interface of R1
Any ideas?
Thanks
============================
R1#sh terminal
Line 2, Location: "", Type: "ANSI"
Length: 45 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600
Status: Ready, Active, No Exit Banner
Capabilities: Receives Logging Output
Modem state: Ready
Group codes: 0
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
never never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: 00:41:15
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are lat pad v120 mop telnet rlogin nasi. Preferred is
lat.
No output characters are padded
No special data dispatching characters
============================================================
R1#sh logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Console logging: level debugging, 102 messages logged
Monitor logging: level debugging, 2 messages logged
Logging to: vty2(0)
Buffer logging: level debugging, 102 messages logged
Trap logging: level informational, 47 message lines logged
Log Buffer (4096 bytes):
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=39957&t=39957
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
