Amazing!!!! I removed logging synchronous on line console 0 and debug worked ....
I am curious, what is the reason for "logging synchronous" preventing debug outputs on terminal lines? Pierre-Alex -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Lidiya White Sent: Saturday, March 30, 2002 5:46 PM To: [EMAIL PROTECTED] Subject: RE: Logging - terminal monitor not working [7:39957] I would add "no ip route-cache" on that interface and make sure that you don't have "logging synchronous" under line con 0... -- Lidiya White -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Pierre-Alex Guanel Sent: Saturday, March 30, 2002 3:04 PM To: [EMAIL PROTECTED] Subject: Logging - terminal monitor not working [7:39957] Kind of a silly problem but can't figure it out ... I am connected to R1 via telnet. I have turned on debugging of ip packets I also have issued the command "terminal monitor" Yet I do not get anything logged when I ping the Ethernet interface of R1 Any ideas? Thanks ============================ R1#sh terminal Line 2, Location: "", Type: "ANSI" Length: 45 lines, Width: 80 columns Baud rate (TX/RX) is 9600/9600 Status: Ready, Active, No Exit Banner Capabilities: Receives Logging Output Modem state: Ready Group codes: 0 Special Chars: Escape Hold Stop Start Disconnect Activation ^^x none - - none Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch never never none not set Idle Session Disconnect Warning never Login-sequence User Response 00:00:30 Autoselect Initial Wait not set Modem type is unknown. Session limit is not set. Time since activation: 00:41:15 Editing is enabled. History is enabled, history size is 10. DNS resolution in show commands is enabled Full user help is disabled Allowed transports are lat pad v120 mop telnet rlogin nasi. Preferred is lat. No output characters are padded No special data dispatching characters ============================================================ R1#sh logging Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns) Console logging: level debugging, 102 messages logged Monitor logging: level debugging, 2 messages logged Logging to: vty2(0) Buffer logging: level debugging, 102 messages logged Trap logging: level informational, 47 message lines logged Log Buffer (4096 bytes): Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=39965&t=39957 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
