I'm trying to configure PPP on a 2514 router. The ISP wants me to use a public IP address on both e0 and s0. The previous ISP had frame-relay and I was using private IP addresses for e0 and NAT overloading.
I want to configure extended NAT on the router but not sure how i can do this if i'm using public IP addresses for both e0 and s0. The internal network is on private IP addresses and configuring a firewall behind the router is not in the budget. New config: (From the ISP) interface Serial0 ip address 162.16.34.94 255.255.255.252 encap hdlc <---default interface FastEthernet0 ip address 164.65.13.89 255.255.255.252 ip route 0.0.0.0 0.0.0.0 162.16.34.93 Old config: (with the previous ISP) interface s0 ip address 167.129.130.198 255.255.255.252 encap frame-relay ietf ip nat outside interface e0 ip address 192.168.1.1 255.255.255.0 ip nat inside ip nat pool Mypool 167.129.130.198 167.129.130.198 netmask 255.255.255.252 ip nat inside source list 100 pool MyPool overload access-list 100 permit .... Thanks for your help. Simer Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=41973&t=41973 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
