I had this same problem on a connection and what I found was the other end was set at 56 and my side was default at 64. Went I set the line speed to match all was well. interface serial 0 service-module t1 timeslots 1-24 speed 64 or service-module t1 timeslots 1-24 speed 56
http://www.cisco.com/warp/customer/471/61.html#command ""Naafi Matovu"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Hi all > > I've been configuring a cisco 2600 dual wic with three subinterfaces on > serial 0/1. > If i leave the the keepalive to 10 sec, the line protocol on the serial 0/1 > keeps coming up but going down after a couple of seconds. The only way i can > keep the line protocol up is (no keepalive) on seial 0/1. Iam not sure > whether this is the best way of sorting out this problem.Here is the current > config on this serial port > > > Serial0/1 is up, line protocol is up > Hardware is PowerQUICC Serial > MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation FRAME-RELAY IETF, loopback not set > Keepalive not set > Broadcast queue 0/64, broadcasts sent/dropped 96/227, interface broadcasts > 96 > Last input 00:00:17, output 00:00:12, output hang never > Last clearing of "show interface" counters 01:26:53 > Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: weighted fair > Output queue: 0/1000/64/0 (size/max total/threshold/drops) > Conversations 0/2/256 (active/max active/max total) > Reserved Conversations 0/0 (allocated/max allocated) > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 11467 packets input, 876671 bytes, 0 no buffer > Received 0 broadcasts, 0 runts, 0 giants, 0 throttles > 33 input errors, 0 CRC, 33 frame, 0 overrun, 0 ignored, 0 abort > 11125 packets output, 799491 bytes, 0 underruns > 0 output errors, 0 collisions, 45 interface resets > 0 output buffer failures, 0 output buffers swapped out > 2 carrier transitions > DCD=up DSR=up DTR=up RTS=up CTS=up Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=42589&t=42350 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
