Your dialer sting needs to be the phone number of the other teletone port. For the first router it should be 8358662 and 8358661 for the second router.
>From: "cebuano" >Reply-To: "cebuano" >To: [EMAIL PROTECTED] >Subject: Basic ISDN BRI config needed [7:45416] >Date: Wed, 29 May 2002 21:32:23 -0400 > >Hi, group. >I've been trying to get my ISDN working using Teltone ILS-2000. Here's my >config >and some basic show output. Please tell me what I'm missing. I tried doing >the >most >basic BRI config using HDLC as pointed out in Caslow, but even that did not >work. >Basically it seems to bring up the link for a few seconds and even bri 0 1 >will show as >UP/UP but I am not getting any ping replies. Any help would be greatly >appreciated. > >Elmer > >2503#ping 172.16.1.2 > >Type escape sequence to abort. >Sending 5, 100-byte ICMP Echos to 172.16.1.2, timeout is 2 seconds: >..... >Success rate is 0 percent (0/5) > >2503# >04:00:33: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up >04:00:53: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 2002 , >call >lasted 20 seconds >04:00:53: %LINK-3-UPDOWN: Interface BRI0:1, changed state to down > >2503# >isdn switch-type basic-ni >! >interface BRI0 > ip address 172.16.1.1 255.255.255.0 > dialer idle-timeout 90 > dialer string 2002 > dialer load-threshold 1 outbound > dialer-group 1 > isdn switch-type basic-ni > isdn spid1 0835866101 8358661 > isdn spid2 0835866301 8358663 > cdapi buffers regular 0 > cdapi buffers raw 0 > cdapi buffers large 0 >! >ip kerberos source-interface any >ip classless >! >dialer-list 1 protocol ip permit > >2503#sh isdn stat >Global ISDN Switchtype = basic-ni >ISDN BRI0 interface > dsl 0, interface ISDN Switchtype = basic-ni > Layer 1 Status: > ACTIVE > Layer 2 Status: > TEI = 74, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED > TEI = 75, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED > TEI 74, ces = 1, state = 5(init) > spid1 configured, spid1 sent, spid1 valid > Endpoint ID Info: epsf = 0, usid = 1, tid = 1 > TEI 75, ces = 2, state = 5(init) > spid2 configured, spid2 sent, spid2 valid > Endpoint ID Info: epsf = 0, usid = 3, tid = 1 > Layer 3 Status: > 0 Active Layer 3 Call(s) > Active dsl 0 CCBs = 0 > The Free Channel Mask: 0x80000003 > Total Allocated ISDN CCBs = 0 > >2503#sh dialer > >BRI0 - dialer type = ISDN > >Dial String Successes Failures Last DNIS Last status >2002 7 0 00:07:11 successful >Default >0 incoming call(s) have been screened. >0 incoming call(s) rejected for callback. > >BRI0:1 - dialer type = ISDN >Idle timer (90 secs), Fast idle timer (20 secs) >Wait for carrier (30 secs), Re-enable (15 secs) >Dialer state is idle > >BRI0:2 - dialer type = ISDN >Idle timer (90 secs), Fast idle timer (20 secs) >Wait for carrier (30 secs), Re-enable (15 secs) >Dialer state is idle > >2503#sh int bri0 >BRI0 is up, line protocol is up (spoofing) > Hardware is BRI > Internet address is 172.16.1.1/24 > MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation HDLC, loopback not set > Last input 00:00:03, output 00:00:04, output hang never > Last clearing of "show interface" counters 00:27:32 > Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: weighted fair > Output queue: 0/1000/64/0 (size/max total/threshold/drops) > Conversations 0/1/16 (active/max active/max total) > Reserved Conversations 0/0 (allocated/max allocated) > Available Bandwidth 48 kilobits/sec > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 138 packets input, 799 bytes, 0 no buffer > Received 5 broadcasts, 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort > 155 packets output, 846 bytes, 0 underruns > 0 output errors, 0 collisions, 0 interface resets > 0 output buffer failures, 0 output buffers swapped out > 2 carrier transitions > >2516# >isdn switch-type basic-ni >! >interface BRI0 > ip address 172.16.1.2 255.255.255.0 > dialer idle-timeout 90 > dialer string 2001 > dialer load-threshold 1 outbound > dialer-group 1 > isdn switch-type basic-ni > isdn spid1 0835866201 8358662 > isdn spid2 0835866401 8358664 > cdapi buffers regular 0 > cdapi buffers raw 0 > cdapi buffers large 0 >! >ip kerberos source-interface any >ip classless >! >dialer-list 1 protocol ip permit > >2516#sh isdn stat >Global ISDN Switchtype = basic-ni >ISDN BRI0 interface > dsl 0, interface ISDN Switchtype = basic-ni > Layer 1 Status: > ACTIVE > Layer 2 Status: > TEI = 72, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED > TEI = 73, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED > TEI 72, ces = 1, state = 5(init) > spid1 configured, spid1 sent, spid1 valid > Endpoint ID Info: epsf = 0, usid = 2, tid = 1 > TEI 73, ces = 2, state = 5(init) > spid2 configured, spid2 sent, spid2 valid > Endpoint ID Info: epsf = 0, usid = 4, tid = 1 > Layer 3 Status: > 0 Active Layer 3 Call(s) > Active dsl 0 CCBs = 0 > The Free Channel Mask: 0x80000003 > Total Allocated ISDN CCBs = 0 > >2516#sh dialer > >BRI0 - dialer type = ISDN > >Dial String Successes Failures Last DNIS Last status >2001 8 0 00:00:07 successful >Default >0 incoming call(s) have been screened. >0 incoming call(s) rejected for callback. > >BRI0:1 - dialer type = ISDN >Idle timer (90 secs), Fast idle timer (20 secs) >Wait for carrier (30 secs), Re-enable (15 secs) >Dialer state is idle > >BRI0:2 - dialer type = ISDN >Idle timer (90 secs), Fast idle timer (20 secs) >Wait for carrier (30 secs), Re-enable (15 secs) >Dialer state is data link layer up >Dial reason: Dialing on overload >Time until disconnect 80 secs >Current call connected 00:00:09 >Connected to 2001 > >2516#sh int bri0 >BRI0 is up, line protocol is up (spoofing) > Hardware is BRI > Internet address is 172.16.1.2/24 > MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation HDLC, loopback not set > Last input 00:00:01, output 00:00:01, output hang never > Last clearing of "show interface" counters 00:29:21 > Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: weighted fair > Output queue: 0/1000/64/0 (size/max total/threshold/drops) > Conversations 0/1/16 (active/max active/max total) > Reserved Conversations 0/0 (allocated/max allocated) > Available Bandwidth 48 kilobits/sec > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 151 packets input, 914 bytes, 0 no buffer > Received 5 broadcasts, 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort > 172 packets output, 964 bytes, 0 underruns > 0 output errors, 0 collisions, 0 interface resets > 0 output buffer failures, 0 output buffers swapped out > 2 carrier transitions _________________________________________________________________ Chat with friends online, try MSN Messenger: http://messenger.msn.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45418&t=45416 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
