Hi.. I have set up the access server AS2509-RJ for remote dial in and I had configured username for authentication (as shown below). But the logging only show the access server had been accessed but not showing who had accessed it. What command should I use to turn it on?
cisco AS2509-RJ (68030) processor (revision K) with 6144K/2048K bytes of memory. Processor board ID 20478542, with hardware revision 00000000 ! username tong password 7 XXXXXXXX username keong password 7 XXXXXXX username kong password 7 XXXXXXXXX 29w4d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async1, changed state to up 29w4d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async1, changed state to down 29w4d: %LINK-5-CHANGED: Interface Async1, changed state to reset 29w4d: %LINK-3-UPDOWN: Interface Async1, changed state to down 29w4d: %LINK-3-UPDOWN: Interface Async1, changed state to up 29w4d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async1, changed state to up 29w4d: %LINK-5-CHANGED: Interface Async1, changed state to reset 29w4d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async1, changed state to do ================================================================== De informatie opgenomen in dit bericht kan vertrouwelijk zijn en is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht onterecht ontvangt wordt u verzocht de inhoud niet te gebruiken en de afzender direct te informeren door het bericht te retourneren. ================================================================== The information contained in this message may be confidential and is intended to be exclusively for the addressee. Should you receive this message unintentionally, please do not use the contents herein and notify the sender immediately by return e-mail. ================================================================== Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=53691&t=53691 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
