Hi Rahul thanks, i got the answer. there was a problem in the ppp layer. After using debug ppp negotionation i came to know. now its working fine. There was no major configuration changes in the client end.
regards deepak Rahul Kachalia wrote: > Deepak, > > I am not sure abt soho router configuration, but what does your > following debugs says on client/server: > > on server > ------- > - debug vpdn pppoe pac > - debug vpdn pac > - debug atm pack - Turn this on if you dont see an debugs with above cmds... > > on client > ----- > - debug vpdn pppoe pac > > thanks, > rahul. > > ""Deepak Nagarajachary"" wrote in message > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > Hi Rahul > > i didnt get the vpdn commands in the SOHO 97 routers for the release of > > 12.2(8)YN. > > > > regards > > deepak > > > > Rahul Kachalia wrote: > > > > > Your client configs are either incomplete or incorrect > > > > > > > > > http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122 > > > t/122t2/ftpppoec.htm#xtocid2 > > > > > > thanks, > > > rahul. > > > > > > ""Deepak Achar"" wrote in message > > > [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > > > > hi all > > > > i am sending the configuration of pppoe connection. > > > > both pvcs are up and atm interfaces are up. but i am > > > > unable to ping either end. i have connecte ethernet > > > > interfaces of two routers back to back. and the adsl > > > > interface of one router is connected to one one port > > > > of the DSLAM and another adsl interface of the second > > > > router is connected to another interface. i have > > > > mapped the pvcs in the DSLAM. > > > > pls can u tell me whats wrong in this setup. > > > > > > > > thanks in advance > > > > regards > > > > deepak > > > > > > > > > > > > Corporate End > > > > > > > > vpdn enable > > > > ! > > > > vpdn-group 1 > > > > accept-dialin > > > > protocol pppoe > > > > virtual-template 1 > > > > ip mtu adjust > > > > ! > > > > ! > > > > ! > > > > ! > > > > ! > > > > interface Ethernet0 > > > > ip address 10.77.152.218 255.255.255.0 > > > > hold-queue 100 out > > > > ! > > > > interface Virtual-Template1 > > > > ip address 192.168.10.4 255.255.255.0 > > > > ! > > > > interface ATM0 > > > > no ip address > > > > no atm ilmi-keepalive > > > > pvc 15/100 > > > > protocol pppoe > > > > ! > > > > dsl operating-mode auto > > > > ! > > > > ip classless > > > > ip route 0.0.0.0 0.0.0.0 10.77.152.129 > > > > ip http server > > > > ip pim bidir-enable > > > > ! > > > > ! > > > > ! > > > > line con 0 > > > > password lab > > > > stopbits 1 > > > > line vty 0 4 > > > > password lab > > > > login > > > > ! > > > > scheduler max-task-time 5000 > > > > end > > > > > > > > ------------------------------------------------------- > > > > > > > > Client End > > > > > > > > ! > > > > ! > > > > interface Ethernet0 > > > > ip address 10.77.152.219 255.255.255.0 > > > > hold-queue 100 out > > > > ! > > > > interface ATM0 > > > > no ip address > > > > no atm ilmi-keepalive > > > > pvc 16/100 > > > > pppoe-client dial-pool-number 1 > > > > ! > > > > dsl operating-mode auto > > > > dsl power-cutback 0 > > > > ! > > > > interface Dialer1 > > > > mtu 1492 > > > > ip address 192.168.10.3 255.255.255.0 > > > > encapsulation ppp > > > > dialer pool 1 > > > > no cdp enable > > > > > > > > ! > > > > ip classless > > > > ip route 0.0.0.0 0.0.0.0 Dialer1 > > > > ip http server > > > > ! > > > > ! > > > > line con 0 > > > > password lab > > > > no modem enable > > > > stopbits 1 > > > > line aux 0 > > > > stopbits 1 > > > > line vty 0 4 > > > > password lab > > > > login > > > > ! > > > > scheduler max-task-time 5000 > > > > end > > > > ------------------------------------------------------ > > > > > > > > > > > > DSLAM configuration > > > > > > > > interface ATM23/1 > > > > no ip address > > > > dsl profile Deepak > > > > no atm ilmi-keepalive > > > > atm pvc 16 100 interface ATM23/1 15 100 > > > > > > > > interface ATM23/2 > > > > > > > > no ip address > > > > dsl profile Deepak > > > > no atm ilmi-keepalive > > > > > > > > ---------------------------------------------------- Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=57676&t=57572 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
