I tried to connect to 2501, even use DCE/DTE to interconnect serial0 and serial1 on 2514, seems the signal cannot go to the line.
Thank you. ----- Original Message ----- From: "Ted Marinich" To: Sent: Thursday, December 19, 2002 5:28 PM Subject: Re: 2514 serial port flipping between up and down, [7:59501] > This may be dumb question, but I have seen this happen when connecting a > high speed port to a low speed port. One side is default to 1544 and the > other cannot do better than 64K. > > So, what are you connecting to, specifically - 2514 to 2522? > > Again, I might not be in the loop, but thought I would put my two cents in > here. > > I did experience the exact same problem and my fix was to set the right > speed on the 2501 to connect to a low speed router interface on a 2522. > > Ted Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=59583&t=59501 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
