Hello all, I've just recently encountered a problem while setting up a pair of Clean Access servers. After installing via CD and configuring each server, I am unable to communicate to the servers via eth0 (NIC1). I've cleanly installed CCA v4.1.3.1 of the software now on 4 different hp Proliant GL360 servers, and they all experience the same issue. I cannot ping the server via eth0. If I connect the servers via eth1 (NIC2), I am able to ping them.
The odd thing is that all 4 servers have been used previously in production with CCA, and I never had this problem with any of these servers before. It is almost as if eth0 is disabled. I have tried ifconfig eth0 up / down / and up again to no avail. I stopped by Cisco's discussion forums and noticed that a couple of individuals have experienced this problem before, but I was not able to find a solution. If anyone can help me resolve this issue, I would greatly appreciate it. Cesar A. Nau Help Desk Manager Fordham University / Fordham IT 718.817.4598 [EMAIL PROTECTED] www.fordham.edu/ITHelp
