On Feb 18, 2014, at 2:50 PM, Alexey Orishko wrote:
Hi guys,
Booting clfs 2.1.0 with two separate eth i/f works fine, but no
description for making bonding work.
I was not able to find any useful info on the subject and its author
replied to the question with
"asking your linux distro vendor".. Well, it is hard in CLFS case :-)
The only option I see now to compile dhcpd client instead and use old
lfs-6.3 setup I have.
Have anyone managed to configure bonding with dhcpcd for at least two
eth interfaces (eth0 and eth1)?
Regards,
Alexey
Follow http://www.linuxfromscratch.org/blfs/view/svn/basicnet/bridge-utils.html
The blfs bootscripts have a service file for bridging.
You can see how it is done.
Install bridge-utils, and put the service file in the proper place.
The same place our clfs bootscripts installed the ipv4 and ipv4-static
and dhcpcd service files if you did install those.
Our bootscripts are a bit different than LFS/BLFS when it comes to
location of files. Our interface config files are in /etc/sysconfig/
interfaces if I recall.
That should get you going. You'll need to inspect the service file
and make sure our ifup ifdn scripts will work properly. Investigate.
Sincerely,
WIlliam Harrington
_______________________________________________
Clfs-support mailing list
Clfs-support@lists.cross-lfs.org
http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org
