this is no resolve ... but have you tried smoothwall? i believe ipcop is based on smoothwall but i stand to be corrected on that.
jon ----- Original Message ----- From: "Shawn Grover" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, September 17, 2003 11:51 AM Subject: RE: (clug-talk) IPCOP v1.3.0 No Web Login | I ran into the same problem with my IPCop router. Admin is refusing the | password, so is root and setup (though these SHOULD). I have the 3 updates | in place on the box, and I was trying to connect to see if there were any | more. I'm sure I'm using the correct password, and have gone so far as to | run "setup" from the command prompt and changed the Admin password. It | still refused to login via the web interface. | | Could this be browser specific? I was using Netscape 7.1 for this. I'll | try with IE tonight... | | Shawn | | -----Original Message----- | From: Kevin Anderson [mailto:[EMAIL PROTECTED] | Sent: Wednesday, September 17, 2003 11:34 AM | To: [EMAIL PROTECTED] | Subject: Re: (clug-talk) IPCOP v1.3.0 No Web Login | | | This is correct. You can only log in as admin. | | Kev. | | | | ----- Original Message ----- | From: "Jason Louie" <[EMAIL PROTECTED]> | To: <[EMAIL PROTECTED]> | Sent: Wednesday, September 17, 2003 9:52 AM | Subject: Re: (clug-talk) IPCOP v1.3.0 No Web Login | | | > Which account are you using to access the Web-admin stuff? I believe | > that not all accounts are avaliable thourgh the web interface, including | > *root*. The account you should be using is *admin*. I believe that by | > default this is the only account that can access the web admin stuff. | > Also be sure that the *admin* account only contains alpha-numeric | > characters. Having *&[EMAIL PROTECTED]<space><tab> may not be passed correctly to | > authenticate the *admin* account. I don't think you need to reinstall | > once you can see the web-admin starting page. Just change the password | > for *admin* when you're logged in as root. | > | > Hope this helps. | > | > Dave Watkins wrote: | > | > >Morning All, | > > | > >Just installed IPCOP on a Compaq Presario 2240 box. All seemed to go | > >well during the installation with both cards being detected. I set up | > >the Green card with an IP of 192.168.123.200 and can ping that address | > >from both W2K boxes and a SuSE 8.2 box. When I browse to that IP with | > >IE6 or Mozilla I get the web interface and the uptime notice updates | > >when refresh button is pressed. The interface also accuratly reflects | > >wether or not I am logged on to the IPCOP box locally as root. | > > | > >The problem is that I cannot log onto the IPCOP box via the Web | > >interface either http or https as such http://192.168.123.200:81 or | > >https:192.168.123.200:445. | > > | > >I have also replaced the IP address with "ipcop", the actual machine | > >name. | > > | > >I have installed this 3 times with the same results. | > > | > >Any suggestions? | > > | > > | > | > -- | > | > Jason Louie BSc. CPSC | > Web Applications Developer | > Sorex Software Inc. | > [EMAIL PROTECTED] | > | > | > | > |
