Hello all:
I am still trying (feverishly) to get my wireless working on my laptop.
I am trying (for starters) to connect to my AP with no security enabled.
I have a Broadcom 4306 running Ubuntu Feisty Fawn.
I have tried a few different ways around this I am now at the following
place:
-ndiswrapper seemed to install and configure fine.
-I have commented out all but the lo interface in
/etc/network/interfaces
-freshly installed network-manager-gnome
+rebooted and ran modprobe ndiswrapper
When I run $sudo ndiswrapper -l
It shows me the bcmwl5 driver I installed with my device, followed by
'(alternate driver: bcm43xx)'
If I look at an lsmod it shows me that ndiswrapper is loaded but used by 0
If I look at the connection information in Network Manager it shows the
driver for Wireless Ethernet (eth1) as bcm43xx
Am I correct in my assumption that ndiswrapper is not being used by the
device, and if so does anyone have suggestions on how to approach the
problem?
_______________________________________________
clug-talk mailing list
[email protected]
http://clug.ca/mailman/listinfo/clug-talk_clug.ca
Mailing List Guidelines (http://clug.ca/ml_guidelines.php)
**Please remove these lines when replying
