Yes,the floor bolt is there. Any pics would be appreciated. Sent from my iPad
On Aug 5, 2012, at 7:16 AM, Graham Collins <[email protected]> wrote: > HI Bill > On my boat the hardware between keel and track looks to be generic shroud > hardware, the only non standard bit is the bolt into the floor - I don't know > how that is fastened in. Hopefully you still have that bit of hardware in > place! > > If you go synthetic try Colligo marine. > > regards, > Graham Collins > Secret Plans > C&C 35-3 > > Bill Striegel wrote: >> Where might I get the bolt attachments to attach the rod/high tech synthetic >> to? Shroud rigging? >> Tks. >> >> Bill Striegel >> 1982 C&C 34 >> "Panacea" >> Ocean Springs, MS >> >> Sent from my iPad >> >> On Aug 4, 2012, at 7:28 PM, "John and Maryann Read"<[email protected]> >> wrote: >> >>> Bill >>> >>> On our 34, there is a stainless rod attaching the babystay track to the >>> keel. It is much like your shrouds. It is located in the forward v berth >>> area just forward of the bulkhead for the head. The upper end is attached >>> to a bolt which is through the deck and track, the lower end is screwed >>> through the floor into the forward edge of the keel. There is a turnbuckle >>> for adjustment. Without this rod, the babystay tension would pull the track >>> out of the deck. >>> >>> Hope this helps >>> >>> John and Maryann >>> Legacy III >>> 1982 C&C 34 >>> Noank, CT >>> -----Original Message----- >>> From: [email protected] [mailto:[email protected]] >>> On Behalf Of Bill Striegel >>> Sent: Saturday, August 04, 2012 10:14 AM >>> To: [email protected] >>> Subject: Re: Stus-List C&C 34: baby stay deck hardware >>> >>> I also cannot find the interior rod to secure the track below in the v >>> berth.any pics? Could lone use high tech rope? How was it attached. To the >>> bolts and the one on the floor? Where can one purchase the screw on >>> attachment points? >>> >>> Sent from my iPad >>> >>> On Aug 3, 2012, at 6:36 AM, Bill Striegel<[email protected]> wrote: >>> >>>> Is this correct? I need to remount it on the deck. Two block atop each >>> other go forward.moveable car bumper to stern. Line arrangement: tie line to >>> forward eye on car,then around top block,then around thimble on car,then >>> around lower block forward,then line to deck V-cleat? The aft thimble on >>> the car is not used. Correct? >>>> Ps: anyone w picture? >>>> >>>> >>>> Bill Striegel >>>> Ocean Springs,MS >>>> Sent from my iPad >>>> _______________________________________________ >>>> This List is provided by the C&C Photo Album >>>> http://www.cncphotoalbum.com [email protected] >>> _______________________________________________ >>> This List is provided by the C&C Photo Album http://www.cncphotoalbum.com >>> [email protected] >>> >>> >>> _______________________________________________ >>> This List is provided by the C&C Photo Album >>> http://www.cncphotoalbum.com >>> [email protected] >> _______________________________________________ >> This List is provided by the C&C Photo Album >> http://www.cncphotoalbum.com >> [email protected] >> > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > [email protected] _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
