Since it attachesd to the deck with fasteners and also uses fasteners to
compress the rubber bushing, one should be able to drill the holes in the deck,
dry fit it, then pull it up, cut a slot in both pieces and the rubber bushing,
slide the cable through the slots in all and fasten it to the deck and compress
it.
Dennis C.
From: Rich Knowles <[email protected]>
>To: "[email protected]" <[email protected]>
>Sent: Sunday, September 23, 2012 4:38 PM
>Subject: Re: Stus-List Holes in deck
>
>That's fine. Now what about the compression nut?
>
>Rich Knowles
>Indigo. LF38
>Halifax
>
>On 2012-09-23, at 17:36, "David Blair" <[email protected]> wrote:
>
>If you can make a clean slit in the rubber bung to the hole you drill for
>the wire size it will fit over the wire then seal nicely when compressed -
>did that with the radar cable when it had a large plug installed on each
>end. They work well. Cheers
>
>-----Original Message-----
>From: [email protected] [mailto:[email protected]]
>On Behalf Of Rich Knowles
>Sent: September-23-12 1:25 PM
>To: [email protected]
>Subject: Re: Stus-List Holes in deck
>
>They are excellent, use them all the time, but they have to be installed
>over the hole and then run the wires. I understood the challenge to be how
>to seal the holes with the wires already run. Hence the goop suggestion.
>
>Rich Knowles
>Indigo. LF38
>Halifax
>
>On 2012-09-23, at 17:10, Charles Nelson <[email protected]> wrote:
>
>Just what I need!
>
>The list never ceases to come thru!!
>
>Thanks,
>
>Charlie Nelson
>
>Sent from my iPad
>
>On Sep 23, 2012, at 8:09 AM, Wally Bryant <[email protected]> wrote:
>
>> Will one of these things fit?
><http://bluesea.com/category/82/productline/overview/1> I have four of them
>for various wires that must pass through the deck. You can add and change
>wires over time, and they're *totally* waterproof. Heck, two of them handle
>wires from my solar panels, which pass through the deck by a stanchion base.
>Probably the wettest place on the boat when sailing in any kind of swell.
>>
>> Wal
>>
>> [email protected] wrote:
>>> What is the easiest, semi-permanent solution to seal the hole with the
>cable in it.
>>
>>
>> --
>> s/v Stella Blue
>> http://www.wbryant.com/
>>
>>
>> _______________________________________________
>> This List is provided by the C&C Photo Album
>> http://www.cncphotoalbum.com [email protected]
>
>_______________________________________________
>This List is provided by the C&C Photo Album http://www.cncphotoalbum.com/
>[email protected]
>
>_______________________________________________
>This List is provided by the C&C Photo Album http://www.cncphotoalbum.com/
>[email protected]
>
>
>_______________________________________________
>This List is provided by the C&C Photo Album
>http://www.cncphotoalbum.com/
>[email protected]
>
>_______________________________________________
>This List is provided by the C&C Photo Album
>http://www.cncphotoalbum.com/
>[email protected]
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]
