If you want to remove the frames without bending them (much), use a machete. After removing the screws, tap the machete down along the top edge between the frame and the cabin top and then gently pry. I wish I had used that method on all four frames. The old spline was shot and I couldn't find a replacement so I used 4200 to seal the new lenses into the frames. It really helped having the frames out of the boat and on a horizontal surface to do this. So far so good.
Bob M Ox 33-1 Jax, FL Looking for comments. > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > [email protected] > >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
