Does your pedestal guard tube not have an aluminum casting with two bolts through the deck at the foot each side? If so. Loosen up the guard at the binnacle, lift it up and you should be able to drill holes through the cockpit sole in the hole in the castings. You can then route cables down the guard. .
Rich Knowles Indigo. LF38 Halifax On 2013-05-04, at 12:09, Robert Gallagher <[email protected]> wrote: I am getting ready to fully wire my Chartplotter/depth/ to power, depth transducer, and Ais GPS that is located down below. There is not enough room to go through the pedestal as the autopilot and engine cables are taking up most of the space and I don't want anything to get tangled. The pedestal guard is the obvious choice but there are NO HOLES down there. Only nuts on studs or bolts at the base of the guard tubes. HELP! A new pedestal guard seems like overkill just to run wires. And yes, I need the chartplotter at the helm. Thanks in advance, I know someone will come up with a solution :) _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected] _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
