On my Barient winches, the part that holds the pawls in place is made of bronze. When it failed, I found a welder to build up the material, and a machine shop that did some machining to finish it. Total cost < $50 It's been more than 15 years ago, and it's just fine.
Don Wagner C&C 41 CB Der Baron ----- Original Message ----- From: Michael Clow To: [email protected] Sent: Tuesday, June 11, 2013 9:28 AM Subject: Stus-List Winches Needed Hello Listers, I have Barient 25-44 two speed winches as my primaries. One has now died. The slot in the aluminum casting that holds one of the pawls broke. I purchased these used in the early 90s so I guess I have gotten good use out of them. I am looking for something similar and wonder if anyone has anything available to sell. I need NON-self tailing, black/dark grey, two speed, and a base diameter of at least 6.75 inches. Hopefully the winches would be less than 10 to 15 years old as I am not sure I want to purchase another set much older than 15 years. You may contact me off list if you desire. Or perhaps some of you have had good experience with a particular vendor of used winches. Michael Clow [email protected] Desire, C&C 32, Lake St. Clair ------------------------------------------------------------------------------ _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
