Dave,
   Don't over think this, really.  Get some needle nose pliers (ones with 
curved nose great) and a small phillips screwdiver.  Put the screwdiver on the 
center drive shaft and apply enough inward pressure to counteract your pulling 
on the impeller.  You should have no problem.  
Bill Walker
Evening Star,
CnC 36
Pentwater, Mi.



-----Original Message-----
From: David Knecht <[email protected]>
To: CnC CnC discussion list <[email protected]>
Sent: Sun, Mar 23, 2014 11:38 am
Subject: Re: Stus-List Impeller/gear puller


Hi Swight- This sounds like something I don’t want to have happen.  I gather 
that if I pull with pliers, it might happen?  So I really need an impeller 
puller?  Dave


On Mar 23, 2014, at 9:00 AM, dwight <[email protected]> wrote:



David
 
What water pump.  I have a Sherwoodpump on mu Universal M4-30 and I need to be 
very careful when pulling theimpellor off the shaft not to disengage the 
impellor drive shaft out altogether…ifI do that the job of impellor replacement 
instantaneously becomes a much biggerjob.
 



From: CnC-List[mailto:[email protected]] OnBehalf Of David Knecht
Sent: March 23, 2014 9:49 AM
To: CnC CnC discussion list
Subject: Stus-List Impeller/gearpuller

 
I need to change myimpeller and after an earlier discussion and difficulty 
removing the presentone, I purchased an inexpensive gear puller to remove it.  
I tried to useit yesterday and found that there was very little space between 
the back of theimpeller and the housing of the water pump, so I could not get 
the arms of thepuller to grab anything.  The arms on the one I bought are quite 
thick. Do I need a different tool?  Thanks- Dave

 

 


DavidKnecht

Aries

1990C&C 34+

New London, CT


<image001.jpg>

 

_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]




David Knecht, Ph.D.    

Professor and Head of Core Microscopy Facility
Department of Molecular and Cell Biology
U-3125
91 N. Eagleville Rd.
University of Connecticut
Storrs, CT 06269
860-486-2200
860-486-4331 (fax)











_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]

 
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
[email protected]

Reply via email to