I use the copper crush washers once. They are cheap like dirt, just use a new one every time you reassemble it.
Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 7 April 2014 15:58, Persuasion <[email protected]> wrote: > Well spring is definitely in the air even though there is still 2 feet > of snow around the boat. This week end I decide to remove the fuel tank to > clean it. All I can say what a major job. Well with the tank nice and > clean it was time to tackle the filters. The fuel lift pump and filter > were very loose, probably could have turned the bolts without the ratchet. > Now the question when I replace the pump and filter can I use some type of > thread lock. If so any recommendations. Also I've always had trouble > keeping the banjo fittings tight at the pump and filter. Anyone else > experience this and how did you over come it. The engine is a 3HMF. > > Thanks > > Mike > S/V Persuasion > C&C 37 Keel/CB > Long Sault > > _______________________________________________ > This List is provided by the C&C Photo Album > http://www.cncphotoalbum.com > [email protected] > >
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com [email protected]
