Hi Chris,
I have two thoughts:
-wow, that's going to take awhile
- I wonder how he is going to keep the bore true?
I expect it to be exceedingly difficult to hone a
barrel "out" by a 1/16th cut and keep the cut even the whole length.
Can you source the correct OD & ID in a shorter length and use two pieces?
Cheers, Russ
Sweet 35 mk-1
Off to SCYC's race around Laqueti Island tomorrow, beer party tonight. TTFN.
At 02:29 PM 06/06/2014, you wrote:
Content-Type: multipart/alternative;
boundary="----=_NextPart_000_000B_01CF81AC.F0FC2C50"
Content-Language: en-us
Hi;
I am replacing the cutlass bearing on CIRCE, our
1970 Redwing 35/ C&C 35 MKI and need advice.
The shaft is 7/8 dia. The strut opening for the
cutlass bearing is 1-1/8 and a length of 3.
I was not able to find a direct replacement for
the bearing. The closest I was able to get is a
7/8 ID cutlass bearing that has a 1-1/4 OD and a length of 3.5
I am planning to hone the opening to 1-1/4
any thoughts
Thanks,
Chris
CIRCE Redwing 35/ C&C 35 MKI (Hull RW7017)
----------
<http://www.avast.com/>
[]
<http://www.avast.com/>
This email is free from viruses and malware
because <http://www.avast.com/>avast! Antivirus protection is active.
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
[email protected]
To change your list preferences, including
unsubscribing -- go bottom of page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________
This List is provided by the C&C Photo Album
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go bottom of page
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
