No clue if you have the same strut as Touche's (35-1 with 7/8 shaft) but I use cutless bearing Duramax ACID. Dimensions sound the same as yours. I think I just centered the bearing in the strut and ignored the "leftover" on each end.
Dennis C. Touche' 35-1 #83 Mandeville, LA On Fri, Jun 6, 2014 at 4:29 PM, JCRaha via CnC-List <[email protected]> wrote: > Hi; > > > > I am replacing the cutlass bearing on CIRCE, our 1970 Redwing 35/ C&C 35 > MKI and need advice. > > > > The shaft is 7/8” dia. The strut opening for the cutlass bearing is 1-1/8” > and a length of 3”. > > > > I was not able to find a direct replacement for the bearing. The closest I > was able to get is a 7/8” ID cutlass bearing that has a 1-1/4” OD and a > length of 3.5” > > > > I am planning to ‘hone’ the opening to 1-1/4”…any thoughts… > > > > Thanks, > > > > Chris > > > > CIRCE – Redwing 35/ C&C 35 MKI (Hull RW7017) > > > > > ------------------------------ > <http://www.avast.com/> > > This email is free from viruses and malware because avast! Antivirus > <http://www.avast.com/> protection is active. > > > _______________________________________________ > This List is provided by the C&C Photo Album > > Email address: > [email protected] > To change your list preferences, including unsubscribing -- go bottom of > page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ This List is provided by the C&C Photo Album Email address: [email protected] To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
