There are spring clips on both sides of the gimbals. You need to push them both
in (away from the oven) at the same time and lift up. I used a piece of 2x4 as
a pry bar and out she comes. Be careful to not damage the propane line at the
rear.
As for rebuilding; there are no parts available for these but there is a
company somewhere in California that will overhaul your controls.
Mike Amirault
C&C 33MKII
SMSC
_______________________________________________
Email address:
[email protected]
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
