Paul, Thank you very much for the information. I’ll contact them today. I’m thinking its just the fitting at the actual keel as I can’t pull the actual line up so I think the loop is still attach, or the loop is no longer a loop but the swagging is still attached and not able to pul through the hole.
Thanks again. Donald > On Jun 12, 2017, at 8:35 AM, Paul Fountain via CnC-List > <cnc-list@cnc-list.com> wrote: > > > I have a 33-II with a centreboard whose pendant broke a couple of years ago. > I had Rob From South Shore yachts make and install the new one. They had an > eye fitting roll swagged on the lower end, which the fed down and attached > with a pin to the board, then hand swagged 2 fittings to make the eye on the > deck end. > > When hauled the board swung just far enough forward to allow you to reach up > and remove and replace the pin. Have a new pin ready! Ours was just about > worse thru. > > Contact for Rob MacLachlan at South Shore Yachts sa...@southshoreyachts.com, > or try calling (works better) tel:905-468-4340 > > > -----Original Message----- > From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Donald > Sebastian via CnC-List > Sent: Monday, June 12, 2017 2:54 AM > To: cnc-list@cnc-list.com > Cc: Donald Sebastian <donaldsebast...@me.com> > Subject: Stus-List centerboard cable broken > > Hello all, > > I have a C&C 33 with a drop keel. Today as I was going to drop the keel, > from its normal 4 1/2 ft to 7 ft, the line was slack. After diving > underneath, the keel is down but it is hard to tell what exactly is going on. > My assumption is 2 things: Either the cable broke, or the pin that the > cable attaches to has broken. > > I have a few questions: > > 1. Can this be repaired while in the water with a diver? Not a great option > to pull locally without demasting. > 2. If I can’t repair immediately, would I cause damage to the keel by > sailing as is for a bit? I didn’t know if there was a stop keeping the keel > from droppiing too far? > 3. If it is the attachment where the cable connects to the centerboard, > does any one have specs on that connection or pictures? > > Thanks, > > Donald > > Louisville, KY > > > _______________________________________________ > > This list is supported by the generous donations of our members. If you wish > to make a contribution to offset our costs, please go to: > https://www.paypal.me/stumurray > > All Contributions are greatly appreciated! > _______________________________________________ > > This list is supported by the generous donations of our members. If you wish > to make a contribution to offset our costs, please go to: > https://www.paypal.me/stumurray > > All Contributions are greatly appreciated! _______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!