thanks for the kind suggestions. the engine is a universal 3 cylinder diesel. I will see if I can at least take a look at the wires.
On Fri, Jul 3, 2020 at 2:50 PM Dennis C. via CnC-List <cnc-list@cnc-list.com> wrote: > Is it a Yanmar? If so, try running a temporary dedicated wire from the > "I" connection on the ignition switch or the positive side of the starter > button to the solenoid. If it starts strongly, make the wire permanent > bypassing the harness near the engine. > > > -- > Dennis C. > Touche' 35-1 #83 > Mandeville, LA > > On Fri, Jul 3, 2020 at 1:22 PM General Gao via CnC-List < > cnc-list@cnc-list.com> wrote: > >> Hi everyone, >> >> I usually have to turn the key a few times for the starter to actually >> rotate. I can hear the solenoid clicking even when the starter does not >> turn. >> >> Would this indicate it is just a wire or connector issue? Or a starter >> issue? Or if further investigation needed, what should be looked at? >> >> Just want to see if I can get advice from the much more experienced >> community. >> >> thank you, >> >> Bo >> _______________________________________________ >> >> Thanks everyone for supporting this list with your contributions. Each >> and every one is greatly appreciated. If you want to support the list - >> use PayPal to send contribution -- https://www.paypal.me/stumurray >> >> > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
