Another report. I flashed the image built by Mychaela, booted from it and re-entered VCXO calibration values into FFS via tmsh. The MS registered with the network in one shot without any problems. I was able to make and receive calls and SMS. I concluded this test by a shot of whiskey in order to celebrate this milestone of the project.
The next step would be to try Citrine with the same FFS content. -Serg On Tue, May 2, 2017 at 1:23 PM, Mychaela Falconia < mychaela.falco...@gmail.com> wrote: > Serg wrote: > > > Last night I have compiled in my VCXO calibration values into > > citrine/L1/cust0/l1_rf12.h and used fcfam load agent to do x-ram boot. > > Please remember that neither Citrine's build system nor that of > Magnetite tracks header file dependencies, so if you edit a header > file (as opposed to a directly compiled C module file) and rerun make > in an already-compiled tree, it may not pick up your change - you may > need to do at least a partial make clean in the area of change. In > the case of your change in Citrine, did you do a make clean at least > in L1/cust0? > > > Still no joy locking on a network. > > Can you post your complete rvinterf session log? If you send me your > ssh public key and your preferred username, I'll make you a user > account on freecalypso.org and you'll have a www-exported member > directory through which you can post files. > > > rf_table afcparams > > [numbers] > > Your numbers look good to me, they are in the same range of per-unit > variation as observed on Openmoko-made GTA02 units. > > > Mychaela, could you share your fwimage.bin? Just would like to make sure > > that I run known good build, free of config errors. > > https://www.freecalypso.org/members/falcon/fcdev3b/ > magnetite-build-20170502.tar.bz2 > > Das Signal wrote: > > > A possible suggestion, consider trying the cell_log application: > > Mychaela has reported success in sending a RACH and receiving an > > IMMASS with the TA. > > Yes, that is correct. I also tried their full mobile application and > was able to send and receive SMS, and some voice calls too - the latter > have always been unreliable for me with OsmocomBB software, even on > pre-existing Calypso hardware. During that weekend in April when I > was preparing boards to ship to Serg and to Harald Welte, I tested all > 8 boards, and for the RF test I used OsmocomBB as that was before I > developed the manual calibration procedure for the VCXO. > > The point is that the board which I sent to Serg *was* tested on my > end with OsmocomBB's mobile application, and it successfully connected > to my local cell of Operator 310260 (T-Mobile USA). > > Later I developed that manual VCXO calibration procedure and performed > it on my S/N 001 board (after Serg's and HW's boards already shipped > out), and I am now able to connect to the same T-Mobile network with > FC Magnetite (l1reconst config) from my S/N 001 board. I have not > tried FC Citrine yet, nor the TCS2/TCS3 hybrid config of Magnetite. > > M~ > _______________________________________________ > Community mailing list > Community@freecalypso.org > https://www.freecalypso.org/mailman/listinfo/community > _______________________________________________ Community mailing list Community@freecalypso.org https://www.freecalypso.org/mailman/listinfo/community